Memorex VR4
Programming the VR4
- Press the device Key (TV,VCR, or CBL).
- Press the PROG (program) key. The red light on the remote will come on.
- Enter the first two-digit code for the selected device using the numbered keys on the remote. (Note: If you wait longer than 30 seconds to enter the code, the indicator turns off. If this happens, return to first step)
- Check to see if the code works by pointing the remote at the device
and pressing POWER.
- If the power on the device comes on you have entered the correct code, and you should proceed to step 6.
- If the power on the device does not come on, press the PROG key, followed by the POWER key again.
- If the light flashes three times and turns off and you have not found a working code, try the next Brand code listed for your device. Press the PROG key, enter the next code, and press the POWER key. Again, be ready to repeat the sequence of PROG, POWER, PROG, POWER until the power on your device comes on, or the red light on the remote flashes three times and turns off. If you do not find a code that works among the codes for your device, try the codes listed under Other Brands, and follow the same procedures.
- When you find a code that turns on the power device, try some of the other functions to make sure they work. Then , press the RECORD button to save the code. The light on the remote will flash once to indicate that the selection has been saved.
- When you have programmed the first device, follow steps 1 through 6 above each other device you wish to use. To program the AUX key, decide which additional device you want the AUX key to operate. Then press AUX, followed by PROG, followed by the device you want to program (TV, VCR, CBL), followed by the two digit brand code. Press PROG POWER PROG POWER as required. When the power on the device comes on, save the setting with the RECORD key.
When you have finished programming the remote, it is strongly recommended that you write the codes that you found to work, on the label that is on the back of the battery compartment cover. This will provide a handy reference later should you have to reprogram your remote control.
TV Codes
|
|
VCR Codes
|
|
Cable Box Codes
|