Sony RM-V11

Setting the Code

1. Set the slide switch on the Remote Commander to VCR (to set up a VCR), CABLE (to set up a cable box), or TV (to set up a TV).
2. If more than one code number is listed, use the number that's listed first to complete the steps that follow. For example, if you're setting up a Philip's VCR, you would use code number 08.
3. Press and release the S (SET) button.
4. Enter the component's code number. For example, if you're entering the code for a Philip's VCR, you would press and release 0, then press and release 8.
5. Press and release the ENTER button to store the code number in the Commander's memory.

If you cannot get the remote commander working with a code from the table, see the instructions below on Searching for the Correct Code.

---

 

Searching for the Correct Code

If you've tried all the code numbers listed for your component and you still cannot get the Commander to work (or if your component is not listed in this manual), try these steps:

1. Power on the component you want to set up. Then set the slide switch on the Remote Commander to VCR (to set up a VCR), CABLE (to set up a cable box), or TV (to set up a TV).
2. Press and release the S (SET) button.
3. Press and release the CH+ button. Then press and release the POWER Button.
4. Repeat step 3 until your component powers off. Pressing CH+ and POWER repeatedly will try every available code until the correct one is found. Be patient as you do this; it may take 50 or 60 tries until the correct code number is located.
5. When the component powers off, press and release the ENTER button to store the code number in the Commander's memory.
6. Check that the Commander is operating the other functions of your component. Press the channel and volume control buttons. If the Commander seems to be working properly, you're done setting up the Commander.