Quik20 Universal Remote Control Programming Codes

These instructions originally appeared on the Metronics International Corporation web site at http://www.m-i-c.com/quik20.htm. The site no longer appears to be active. This page is an archived copy of the content on the defunct site.

1.Locate the 3-digit brand code from tables below.

2.Press and HOLD thr RCL and ENT keys simultaneosly, until the red indicator turns on (3-4 sec)

3.Select the type of device you are programming by pressing the TV, VCR, CTV or AUX key.

4.Enter the 3-digit brand code number. If a valid code was entered, the indicator light will go off.

5.Test your Gemini Quik 20 remote,by pressing PWR key. Repeat 2-5 with new code number if not responding.

Autosearch Instructions:

1. Turn ON the device you wish to program the Quik 20 to operate.

2. Press and HOLD the RCL and ENT keys simultaneosly, until the red indicator light turns ON.

3. Select the type of device you are programming by pressing one of the TV, VCR, CTV or AUX mode keys. Now enter one of thr following device type search codes: TV-990, VCR-992, Cable-994.

4. Aim the Quik 20 at the device and press the red PWR key. If your device turns OFF, press the appropriate device mode key again,(TV,VCR,CTV or AUX),to lock in brand code for that particular device and exit from the programming mode.

5. If the device doesn't respond, press the VOL"+" key once to advance to the next brand code. Now press the PWR key again. Remember to immediately lock in your code when the component turns OFF by pressing the proper mode key. Continue repeating steps 4&5 until your device turns OFF.